Products News All   Home Contact Site map Türkçe
 
 

Main > Technical > Dimensional requirements
 
Before installation of the seal one must assure that any sharp edges on the housing, shaft or rod are to be rounded off and any lead-in edge is to be properly chamfered as this would avoid any potential damage to the sealing lip. Rod, piston and housing surfaces need to be precisely fabricated and finished. Below you can find the dimensional requirements from respective standards.

Rotary shaft seals, housing
Rotary shaft seals, shaft

Fluid power rod seals
Fluid power rod seals (elastomer-energized)

Fluid power piston seals
Fluid power piston seals (elastomer-energized)
Fluid power piston seals (compact)

Fluid power wiper seals (Type A)
Fluid power wiper seals (Type B)
Fluid power wiper seals (Type C)
Fluid power wiper seals (Type D)

 
 
All rights reserved (c) 2007 SUPTEK Yag Keceleri San. ve Tic. A.S.